CANOGA PERKINS 9145ELB NID Software Version 4.01 - Manual (Page 123)

Configuring EVC 9145ELB NID Software User’s Manual
EVC Configuration
113
Figure 10-6 Modify EVC Configuration screen (All-to-One)
3. To change the Administrative State, type 1 and press Enter. Press the Space bar to select
Up or Down, and press Enter.
4. To change the statistics display, type 2 and press Enter. Press the Space bar to select S-
VLAN, C-VLAN, or Disabled, and press Enter.
If you set the statistics mode for a service multiplexing record to C-VLAN then you can
see the service multiplexing statistics detailed at C-VLAN level (as in Figure 10-16).
To change the S-Tag PCP Value, type 3 and press Enter. Press the Space bar to select
Map from CVID, Static or Copy from Ingress, and press Enter.
5. To change the Static/Default PCP value for the S-Tag, type 4 and press Enter.
6. To change the T-Tag PCP value, type 5 and press Enter. Press the Space bar to select
Map from CVID, Static or Copy from Ingress, and press Enter.
7. To change the Static/Default PCP value for the T-Tag, type 6 and press Enter.
8. To change the CoS classification mode, type 7 and press Enter. Press the Space bar to
make a selection.
9. To modify CoS to Queue mapping, type 8 and press Enter. For steps, see “Viewing or
Modifying the C-VLAN List” on page 118.
10. To modify the assigned policer profile, or allocate new policers to EVC or EVC/COS, type
9 and press Enter. The VLAN/COS Policing screen (Figure 10-7) opens. Note that if the
EVC belongs to a User Port for which policing is enable at the port level, this screen is
read only and displays the port-level policer information.
Canoga Perkins Corp. Ethernet 1G/10G Network Interface Device 29-AUG-2011
9145ELB-971-4-0 V04.01 10:55:13
-----------------------MODIFY EVC CONFIGURATION RECORD--------------------------
S-VLAN ID: 2 (88A8) TTag: Disabled 0 (8100)
User Interface: USR2
Network Interface: NET1
Name: dfgdfg
Multiplexing type: All-to-One
Operational state: DOWN
1) Administrative state: UP
2) Statistics: S-VLAN
3) S-Tag PCP Value: Copy from ingress 4) Static/Default PCP Value: 1
5) T-Tag PCP Value: Copy from ingress 6) Static/Default PCP Value: 0
7) CoS Classification Mode: PCP 8) CoS to Queue Mapping
9) Assign Policer Profile
10) CVID to S-Tag PCP Mapping 11) CVID to T-Tag PCP Mapping
12) P-Bit Translation
Select [1-12] for attributes:
------------------------------------Messages-----------------------------------