CANOGA PERKINS 9145ELB NID Software Version 4.01 - Manual (Page 69)

Port Information 9145ELB NID Software User’s Manual
Port Configuration
59
5.2.2 Port Config/Status Screens
From the Port Configuration screen (Figure 5-3), select Port Config/Status (2) and press Enter.
You are prompted for a Port: U1-16, 10G1, or 10G2. The Config/Status screen opens:
The Config/Status screen displays the User and Network Port speed and duplex information, and
allows you to set the functions listed below. To modify the settings, type the number of the setting
and press Enter.
Figure 5-5 U1 Config/Status screen
Option 5 on this screen configures port 10G2. When you select port 10G2 for configuration, the
10G2 User/Network Mode can be configured whereas on the other ports, the mode of the 10G2
port is displayed for informational purposes only. It can only be changed from User to Network
modes when you select 10G2 for port configuration. When configured as a Network Port, the
menu appears as in Figure 5-6, to reflect the services offered in network mode.
NOTE: When you switch port 10G2 from UNI to NNI, User Ports 9-16 are disabled and must be
enabled manually.
Canoga Perkins Corp. Ethernet 1G/10G Network Interface Device 08-OCT-2011
9145ELB-B83-M-0 V04.01 22:37:16
------------------------------- U1 CONFIG/STATUS -------------------------------
Port : U1 Physical Status : Link Down
Port Type : 100M/1G SFP SFP Model Number : Not Present
Link Status : Link Down Link Transitions : 0
1) Speed Setting : 1000M Full
2) L2CP Port Filters
3) RMTF : Disabled
4) RMTF Mode : CP Proprietary
5) LLF Participation : Disabled
10G2 User/Network Mode : User (Ports U9-U16 disabled)
Policing Policer Bandwidth Profile
-------- ------- -----------------
6) Disabled N/A N/A
Select [1-6, (G)oto]:
------------------------------------Messages---------------------------------------------