CANOGA PERKINS 9145ELB NID Software Version 4.01 - Manual (Page 71)

Port Information 9145ELB NID Software User’s Manual
Port Configuration
61
The settings are listed below:
RMTF Enables or disables remote fault configuration on ports.
LLF Participation Enables or disables link loss forwarding on ports.
L2CP Port Filters L2CP Filters can be used to filter out specific control protocol frames from the
data stream. This port-based filtering mechanism will inspect each received packet for specific
protocol markers (such as destination multicast address, protocol type, protocol sub-type, etc.).
If the filter for the particular protocol is enabled for the port, the port will discard the packet. Port
Filters can be setup for each port independently.
1. To configure L2CP filters, type 2 and press Enter. The L2CP Port Filters (Figure 5-8)
screen opens.
Figure 5-8 L2CP Port Filters screen
2. Type the number of the filter you wish to modify and press Enter. Use the space bar to
enable or disable the filter.
User UTP Port Settings
User and Network Port SFP
Settings
Disabled
10M Half
10M Full
10M Auto
100M Half
100M Full
100M Auto
10/100M Auto
1000M Full
10/100/1000M Auto Disabled
100M Half
100M Full
1000M Full
1000M Auto
10000 Full
Canoga Perkins Corp. Ethernet NID with Dual 10G Ethernet Uplink 29-AUG-2011
9145ELB-B83-M-0 V04.01 01:49:22
----------------------------- U1 L2CP PORT FILTERS -----------------------------
Port : U1 Physical Status : Link Down
Port Type : 100M/1G SFP SFP Model Number : Not Present
Link Status : Link Down Link Transitions : 0
1) STP MSTP RSTP BPDU Filter : Disabled 9) MMRP Filter : Disabled
2) Pause Filter : Disabled 10) CDP Filter : Disabled
3) LACP Filter : Disabled 11) VTP Filter : Disabled
4) Port Authentication Filter : Disabled 12) PagP Filter : Disabled
5) E-LMI Filter : Disabled 13) PVST+ BPDU Filter : Disabled
6) Provider Bridge Filter : Disabled 14) Link OAM PDU Filter : Disabled
7) LLDP Filter : Disabled 15) UDLD Filter : Enabled
8) MVRP Filter : Disabled
Select [1-15, (G)oto]:
------------------------------------Messages-----------------------------------