ChemoMetec SP-100 - Manual (Page 32)

4 Installation and Start-up
14
After a successful start-up the display changes ( Figure 13 ) and the status indicator on
the keyboard panel turns green.
Display Text Type 2
SP SP SP SP- - - -100 100 100 100
Ready Ready Ready Ready
ID: ID: ID: ID:- - - - DF=201 DF=201 DF=201 DF=201
Figure 13. The NucleoCounter SP-100 is ready for cell counting
If the instrument has performed as described above, it is ready for use. If the
instrument displays an error message at start-up refer to chapter 4.
Pressing the “ On/Off” button shuts down the NucleoCounter SP-100 and while the
instrument shuts down the display will momentarily look as shown in Figure 14 .
Display Text Type 3
Bye... Bye... Bye... Bye...
Figure 14. The shutdown display .
4.2 Installation of SemenView
Regarding installation of the SemenView PC-software, please refer to the SemenView
User’s Guide.
4.3 Connection to PC via an USB interface and Installation of SemenView
Connection of the NucleoCounter SP-100 to a PC via the USB interface (see USB port in
Figure 1 ) and installation of the SemenView PC-software is described in the SemenView
User’s Guide .
4.4 Connection to Printer via Printer port (RS-232)
Connection of the NucleoCounter SP-100 to a Printer via the Printer port (see RS-232
Printer port in
Figure 1 ) and installation of the Printer is described in Technical Note no.
100 .
4.5 Connection to PC via Printer port (RS-232)
Connection of the NucleoCounter SP-100 to a PC via the Printer port (see RS-232 Printer
port in
Figure 1 ) and installation of the PC is described in Technical Note no. 100.