ChemoMetec SP-100 - Manual (Page 34)

5 Operation of NucleoCounter SP-100
16
When a specific setting or a value is saved the display will for a few seconds show
“storing” or “saving” (there is no difference between saving and storing. The
expressions are used indiscriminately):
Display Text Type 6
stori stori stori storing ng ng ng
Figure Figure Figure Figure 18 18 18 18. The function that has been chosen is stored. Wait a few seconds for getting
to the “ Ready” mode.
Display Text Type 7
saving saving saving saving
Figure Figure Figure Figure 19 19 19 19. The function that has been chosen is saved. Wait a few seconds for getting
to the “ Ready” mode.
If the stores/saved values shall replace the present default values or settings this can
be achieved in connection with shutting down the instrument. When a parameter has
been changed the instrument will show the following text in the display:
Display Text Type 8
Save parameters? Save parameters? Save parameters? Save parameters?
↵ ↵ ↵ ↵ : Save : Save : Save : Save
Esc: Cancel Esc: Cancel Esc: Cancel Esc: Cancel
Figure Figure Figure Figure 20 20 20 20. . . . Save the settings and use these as the new default setting?
Press “ ↵ ↵ ↵ ↵ ” to save the changes as the new default settings or press “ Esc” in order not to
overwrite the existing default settings. When pressing “ Esc” all changes will be lost and
next time the instrument is turned on, the old settings will be used again.
5.2 “Ready” status
After the NucleoCounter SP-100 has started successfully the display should read:
Display Text Type 2
SP SP SP SP- - - -100 100 100 100
Ready Ready Ready Ready
ID: ID: ID: ID:- - - - DF=201 DF=201 DF=201 DF=201
Figure 21. The NucleoCounter SP-100 is ready for cell counting. No Sample ID is chosen.
Dilution Factor is set to 201.