COP-USA NVR2816NE-L - Manual (Page 18)

NVR User Manual
12
3 Basic Function Instruction
3.1 Startup and Shutdown
Please make sure all the connections are done properly before you power on the unit. Proper startup and shutdown are crucial
to expanding the life of your NVR.
3.1.1 Startup
Step1: Connect with the source power.
Step2: The device will boot and the power LED would turn blue.
Step3 A WIZZARD window will pop up and show some information about time zone ，time setup，network configuration, record
configuration and disk management. You can setup here and refer to the concrete setup steps from the corresponding chapters.
If you don‟t want to setup Wizard, please click Exit button to exit.
Note: The default output is HDMI output. This NVR can only display options on either VGA /HDMI monitor or CVBS monitor at a
given point of time, if there is live image display without menu options then please check if there is display on other device/monitor,
or long press ESC key to wait for login dialog box to appear. Long press ESC key can switch the output between CVBS and
VGA/HDMI.
3.1.2 Shutdown
You can shut down the device by using IR remote controller and mouse.
By IR remote controller:
Step1: Press Power button. This will bring up a shutdown window. The unit will shut down by clicking “OK” button.
Step2: Disconnect the power.
By mouse: