COP-USA NVR2816NE-L - Manual (Page 83)

NVR User Manual
77
② select Security------Custom Level….Refer to Fig 8-1.
③ Enable all the sub options under “ActiveX controls and plug-ins”. Refer to Fig 8-2.
④ Then click ok to finish setup.
b. Other plug-ins or anti-virus may block ActiveX. Please disable or do the required settings.
Fig 8-1 Fig 8-2
Q9: NVR displays “please wait…”all the time.
a.HDD power cable and data cable may not be well connected. Please check the connections for HDD.
b. It is also possible that the NVR was forced to stop because HDD has a bad sector and it may have caused the system to
halt. Check with a good known HDD or try formatting the existing HDD.