COP-USA NVR2816NE-L - Manual (Page 38)

NVR User Manual
32
It is an inbuilt alarm output device. To setup Buzzer:
Step1: Enter into MenuSetupAlarm out Buzzer tab;
Step2: Checkmark Buzzer and set buzzer alarm hold time. This would trigger
the buzzer when the system is in alarm.
5.6 Network Configuration
Network configuration includes three submenus: network, Email and other
settings. Network settings must be configured if NVR is used for monitoring
over network.
5.6.1 Network
Step 1: Enter into MenuSetupNetworknetwork tab. Refer to Fig 5-27:
Step 2: HTTP port: the default value is 80. If the value changed, you need to
modify the IP address in the IE address .i.e. if HTTP port is set to 82 and IP
address is,
192.168.0.25 , then you shall input IP address as Fig 5-27 Network Configuration-Network
http://192.168.0.25:82 in IE browser.
Server port: Communication port.
Step 3: Connect internet. If you have a DHCP server running and would like your NVR to automatically obtain an IP address and
other network settings from that server, check the checkbox beside "Obtain an IP address automatically". Then the device will
distribute IP address, subnet mask, and gateway IP and DNS server. If you want to configure your own settings, please input the
IP address, Subnet mask, Gateway DNS server manually. You can also check the PPOE checkbox to enable this feature and then
enter username and password. Once the setup is completed, your NVR will automatically dial up into your network.
Step 4: No matter what kinds of way to connect internet, you should test the effectiveness of the network by clicking “Test”
button after you setup the network.
Step 5: If the network is well connected, please click “Apply” button to save settings.