COP-USA NVR2816NE-L - Manual (Page 37)

NVR User Manual
31
5.5.3 Other alarm
This tab gives a choice to configure alarm for Disk Full, IP Conflict, the
Disconnect event or Disk Attenuation.
Step1: Enter into MenuSetupAlarmOther Alarm interface. Refer
to Fig 5-25:
Step 2: Use the dropdown menu and select the event or the alarm.
Step 3: Check the required trigger options.
If the selected event is “Disk Full”, then use the drop down box for
“Disk Shortage Alarm” to choose a threshold value for remaining HDD
space. If the threshold value is reached, the system will trigger the
Disk Full Alarm.
Click “Apply” to save settings; Click “Exit” to exit the current interface.
Fig5-25 Other Alarm
5.5.4 Alarm out
Alarm out includes three sub menus: alarm out, schedule and buzzer
To setup alarm out:
Step 1: Enter into MenuSetupAlarm out tab. Refer to Fig 5-26.
Input relay name and hold time.
Step 2: Select the Schedule tab. This will bring up the schedule setup
interface. The setup steps for schedule for alarm out are similar to
normal schedule setup; you can refer to 5.4.1 Schedule for details.
This step is very important for alarm out. Even if you have enabled
alarm out in the motion based alarm or sensor based alarm, you will not
see the result of alarm out if no schedule is added here.
Fig 5-26 Alarm Out
Buzzer