COP-USA NVR2816NE-L - Manual (Page 35)

NVR User Manual
29
Step 6: Enter into alarm tab to select the options to handle alarm.
Buzzer: If selected, the local buzzer would be activated on an alarm.
Full screen alarm: If selected, there will pop up the chosen channel on
the monitor on an alarm trigger.
To alarm out: If selected, this would trigger the external relay output on
detecting a sensor based alarm.
Email: If you select this option, the NVR will send an email alert to the
preconfigured email address in case of a sensor based alarm from the
particular input.
Step 7: Enter into To Record tab. Select recoding channels. It would be
recorded in case of an alarm. Click OK button to save the setting.
Fig 5-21 Sensor-Schedule
Step 8: Enter into Schedule tab. Refer to Fig 5-21. The setup steps for schedule for sensor based alarm are similar to normal
schedule setup. You can refer to Chapter 5.4.1 Schedule for more details. This step is very important for sensor based alarm.
Although you have enabled the sensor based alarm for all channels and setup the trigger, you will not see the result of sensor
based alarm if no schedule is added.
If you have set the schedule for senor based recording in the same timeline, recordings can also be triggered.
5.5.2 Motion Alarm
Motion includes two sub menus: motion and schedule.
The steps to set up motion alarm are as follows:
Step1: Enter into MenuSetupAlarmMotion tab. Refer to Fig 5-22:
Step2: Enable motion alarm, set alarm hold time which refers to the time till
which the system will wait for further detection of motion. Eg. If the holding
time is set to 10 seconds, once the system detects a motion, it will go into
alarm but would not detect any other motion alarm (specific to channel) until
30 seconds. If there is other motion detected during this period, it is considered
Fig 5-22 Alarm Configuration-Motion
it as continuous movement, otherwise it will be considered as a single motion.