COP-USA NVR2816NE-L - Manual (Page 36)

NVR User Manual
30
Step3: The setup steps of motion trigger are similar to „Alarm Handling‟. You can refer to Chapter 5.5.1 Sensor Alarm Handling
for more details.
Step4: Click “Setting” button under the Area to display the following picture
as shown in Fig 5-23:
Step5: In the Area tab, you can drag slide bar to set the sensitivity value (1-8).
The default value is 6. The higher the value is the more sensitive it is to
motion. Since the sensitivity is influenced by color and time (day or night),
you can adjust its value according to the practical conditions. Click
icon
to set the whole area as detection area. Click icon to clear the set
detection area. Click icon to test the sensitivity as per the local
conditions. Once motion is sensed, it displays a figure icon. Click icon to
save the setting. Click icon to exit the current interface.
Note: Prior to setting motion detection field it is recommended that you click
icon to clear the existing field and set afresh. Fig 5-23 Motion-Area
Step6: Select “All” to setup all channels with the same parameters.
Step7:Click “Apply” button to save the setting; click “Exit” button to exit the
current interface.
Step 8: Enter into Schedule tab. Refer to Fig 5-24: The setup steps for
schedule for motion based alarm are similar to normal schedule setup; you
can refer to 5.4.1 Schedule for details.
This step is very important for motion alarm. Although you have enabled
the motion based alarm for all channels and setup the trigger, you will not
see the result of motion based alarm if no schedule is added.
If you have set the schedule for motion based recording in the same
timeline, recordings can also be triggered.
Fig 5-24 Alarm Configuration-Schedule