COP-USA NVR2816NE-L - Manual (Page 26)

NVR User Manual
20
Show System Time: If selected, displays the current time during live monitoring.
Max Online Users: To set the maximum number of concurrent user logins in the NVR.
Show wizard: If selected, the GUI would launch the startup wizard on every boot, allowing the to do basic setup.
Video Output: Resolution of live display interface, ranges from: VGA800*600, VGA1024*768, VGA1280*1024,CVBS and HDMI.
Note ： Switching between HDMI/VGA and CVBS will change the menu output mode. Please connect to relevant monitor.
Language: To setup the menu language.
Note: After changing the language and video output, the device needs to login again.
Logout After (Minutes): You can setup the screen interval time (30s, 60s, 180s,
300s). If there is no any operation within the setting period, the device will auto
logout and return to the login interface.
No Image When Logout: If selected, there will be no image showing when logout.
5.1.2 Date & Time
Step1: Enter into MenuSetupBasicDate & Time tab. Refer to Fig 5-4:
Step2: Set the date format, time format, time zone in this interface; checkmark “sync
time with NTP server” to refresh NTP server date.
Fig 5-4 Basic Configuration-Date & Time
You can adjust system date manually
Step3: Click “Default” button to restore default setting; click “Apply” button to
save the setting; click “Exit” button to exit the current interface.
5.1.3 DST
Step1: Enter into MenuSetupBasicDST interface. Refer to Fig 5-5:
Step2: In this interface, enable daylight saving time, time offset, mode, start &
end month/week/date, etc.
Step3: Click “Default” button to restore default setting; click “Apply” button to
Fig 5-5 Basic Configuration-DST
save the setting; click “Exit” button to exit the current interface.