COP-USA NVR2816NE-L - Manual (Page 34)

NVR User Manual
28
5.5.1 Sensor Alarm
Sensor includes three sub menus: basic, alarm handling and schedule.
Operate the following steps to configure sensor alarm:
Step1: Enter into MenuSetupAlarmSensorBasic interface. Refer to Fig
5-18:
Step2: Enable channels by checking the checkboxes beside the desired
channels .
Step 3: Set the alarm type according to triggered alarm type. Two option: NO
and NC.
Step4: Click “Apply” button to save settings.
Step5: Enter into Alarm Handling tab. Refer to Fig 5-19.
Fig 5-18 Alarm Configuration-Sensor-Basic
Select hold time and then click Setting button. A dialog box will pop-up as Fig 5-20:
Fig 5-19 Alarm Configuration-Sensor-Alarm Handling Fig 5-20 Alarm Handling-Trigger