Hardy HI 1769-FC - Manual (Page 15)

10
●
●
●
●
●
Chapter 3
Module connector removed for easier cabling
Step 3: Gently pull he connector off of the board in the module
Step 4: To install the connector reverse steps 3 & 3.
Step 5: Install the cable so it allows the module door to close
Step 6: Check to make sure that the wires are securely connected before operating the
module.
NOTE Most of the problems with modules are due to loose connections. Be sure to check the I/O
connection first in the event you have a problem receiving information from the load
cells.