Hardy HI 1769-FC - Manual (Page 35)

30
●
●
●
●
●
Chapter 4
Command Hex Description
RATE_CAL_5POI
NT_CMD 0x60 Runs the 5-point rate calibration at whatever points have
previously been defined.
RATE_CAL_2POI
NT_CMD 0x61
Runs the 2-point rate calibration at whatever points have
previously been defined.
RATE_CAL_AD
VANCED 0x62 This command fills in the 7 calibration points with values
extrapolated from 2 entered points, 2 and 4 of a 5-point
calibration. The 2 percentages are entered at offsets 5 and
6 as in the
RATE_CAL_2_POINTS_DEFINED command, and
the 2 rates are entered at offsets 7 and 8. The rates have
“rate decimal places”, as set in the FORMAT word at
offset 1.
CALLOWCMD 0x64 Sets the “calLowCount” parameter to the current A/D
average counts when doing a hard calibration. Calls an
Integrated Technician function during low calibration.
Error Return Values:
STATUSWORD - There was a conversion error or A/D
conversion failure.
CALHIGHCMD 0x65 Sets the Span Weight parameter to the current A/D
average counts when doing Hard CAL.
Error Return Values:
STATUSWORD - There was a conversion error or A/D
conversion failure.
HARDCALFAILCOUNTS - There are less than 1000
counts between the zero and the span weights.
C2CALCMD 0x66 Performs a C2 Calibration. Uses CalLowWeight as the
reference point.
Error Return Values:
STATUSWORD - There was a conversion error or A/D
conversion failure.
C2FAILNODEVS – Detected no C2 load cells.
C2FAILCAPEQ - Detected two load cells with different
capacities.
WRITEPARAM 0x67 Writes the parameters. See Parameter Table below.
Return Data:
COMMAND STATUS - The status is 0 if the command
succeeded. If a range error was detected. See Status Table
below.
READPARAM 0x69 Reads the parameters. See Parameter Table below.
Return Data:
COMMAND STATUS See Status Table below.
PARAMETERS
SETDEFAULTPA
RAMS 0x94 Loads the default settings into RAM, and non-volatile
RAM. Error Return Values: None