Chapter 4 - setup, A brief description of chapter 4, Power check – Hardy HI 1769-2WS User Manual
Page 35: A brief description of chapter 4 -1 power check -1
Chapter 4 - Setup
4-1
CHAPTER 4 - SETUP
A Brief Description of
Chapter 4
All information contained in Chapter 4 pertains to
firmware and software settings to prepare the module
controller for calibration and operation. Alternatives
to these procedures either explicit or implied, con-
tained in this section are not recommended. It is very
important that the user and service personnel be
familiar with the procedures contained in this chapter,
before going through the setup procedures. The Setup
procedures require Allen-Bradley’s RS Logix 5000
(CompactLogix) or RS Logix 500 (MicroLogix 1500)
Allen-Bradley RSLinx™ or RSLinx™ Lite.
Power Check
Step 1.
Check to see that there is power to the
PLC and the module.
Step 2.
If there is power to the module, the LEDS
should be lit. (See Fig. 4-1 and 4-2)
Step 3.
To make any settings the LED’s should be
lit for normal operation:
FIG. 4-1 MODULE LEDS HI 1769-WS SINGLE
CHANNEL