Hardy HI 2151/30WC Single-Scale Controller - Manual (Page 18)

HI 2151 Series Weight Controller
Profibus Interface Option
12
Figure 3-2
6. Press the Test/Clr button. The display should now show four “0's”. (See Fig. 3-3)

NOTE: On an uncleared display, numbers are added to the right of the existing number.
Figure 3-3
7. Use the keypad to enter the new number.
8. Press the “Enter” button to set the address.
9. Exit the Options Menu by pressing the “Exit” button.

NOTES:
1. It may be necessary to configure the PLC (using manual or auto configuration) in
addition to powering down and powering up the instrument to activate the new menu
selections. See your PLC manual to determine if this is necessary
2. The PROFIBUS Station Address cannot be changed through the PROFIBUS Network.
3. The PROFIBUS node address number is displayed in decimal on the weight controller.