Hardy HI 2151/30WC Single-Scale Controller - Manual (Page 25)

Section 4: Block Reads
19
4.8 BLOCK READ DATA NUMBERS
Block Read Data Number 20: Full Status and Weight Data
Byte Definitions Byte Pos. #
Words
Start Word # Bytes Start Byte
Block Read Number 20 (Hex 14)
Indicator Status 1
Rate of Change currently displayed
Set point Relay 2 Active
Set point Relay 1 Active
Peak Force (weight) currently displayed
Totalized weight currently displayed
Reserved for future use
Reserved for future use
Reserved for future use
Indicator Status 2
Weight currently displayed in pounds units
Zero Track feature enabled
Reserved for future use
Current Gross weight = 0
Weight in motion, i.e. changing
Gross Weight currently displayed
Net Weight currently displayed
Weight currently displayed in kilogram units
Dipswitch Settings (Exterior)
Re-calibrate toggle
Option menu keypad lockout
Set point menu keypad lockout
Lb/Kg, Net/Gr, Tare, Zero keypad lockout
Zero tracking enable
Reserved for future use
RS 232 command lockout
Multi-drop enable (RS 422 only)
Dipswitch Settings (Interior)
Reserved for future use
Enable Gross Weight output on RS232 port
once per second
Calibration lockout for NTEP (Legal for Trade)
mode
Ignore incoming serial checksums (RS232 port)
Peak force is a result of averaged gross weight
NTEP (Legal for Trade) mode enable
Eliminate “>” on print out (RS232 port)
Reserved for blind unit toggle
Remote Functions Status
Force display to Rate-of-Change
Add current net weight to total
Hold value on display
Hold option card updates
Force display to Net weight mode
Toggle Lbs/Kg
LSB
MSB
bit 0
bit 1
bit 2
bit 3
bit 4
bit 5
bit 6
bit 7
LSB
bit 0
bit 1
bit 2
bit 3
bit 4
bit 5
bit 6
bit 7
MSB
bit 0
bit 1
bit 2
bit 3
bit 4
bit 5
bit 6
bit 7
LSB
bit 0
bit 1
bit 2
bit 3
bit 4
bit 5
bit 6
bit 7
MSB
bit 0
bit 1
bit 2
bit 3
bit 4
bit 5
1
1
1
0
1
2
1
1
1
1
1
1
0
1
2
3
4
5