Kistler-Morse KM SVS2000 - Manual (Page 32)

28
97-1129-01 Rev. D
www.kistlermorse.com
Tare
Used in Run Mode only. Press the Tare Key for 1 second to ‘tare’ the vessel, setting the net weight
value to zero. The SvS2000 briefly shows Tare Implemented and then switches to the net weight
display. The tare function is useful when you want to monitor how much material is added to or
removed from the vessel from a given point. note that the total weight display is updated each time
the vessel is tared. note:The SvS2000 also has a remote tare function. See TI-SvS-02 in electrical
System, for wiring details. To tare the vessel from the remote station, hold the remote tare push
button for 1 second.
Zero
used in run mode:
• On the gross weight display — Press the Zero key to change the calibration for the vessel,
setting the gross weight value to zero. The Zero Key is useful when you want to quickly adjust the
calibration for an empty vessel without entering the menu tree. See the Run Mode Display section
in this chapter for details.
• On the total weight display — Press the Zero key to reset the total weight to zero. See the run
Mode Display section in this chapter for details
Enter
Has several functions:
• In run mode —
—gross weight display: Press the enter key to toggle from numerical format to bar graph format.
The display remains in the bar graph format (even if the SVS2000 is turned off and back on again)
until the Enter Key is pressed to toggle back to the numerical format.
—Total weight display: Press the enter key to briefly display the number of tares since the last time
the totalizer was reset.
• In Function mode —
—Press the enter key to access submenus. For example, if the display shows:
21 AuTO CAL
pressing the enter key advances to the first Auto Cal submenu:
LO SPAn CAL
Pressing the enter key again advances to the display where the value for the Lo Span is entered:
> lbs
—Press the enter key to save in memory any parameter set up in the menus. For example, when
setting Lo Span Cal, pressing the enter key saves it to memory. The value remains in memory until
a new value is entered.
numeric
Has several functions:
• run mode — Press numeric keys to enter the function number for the desired menu in the menu
tree (press the Enter Key after the number is entered).
• Function mode — Press numeric keys to type in numbers to set up the SvS2000. If you make an
error while typing a number but haven’t pressed the enter key yet, do one of the following:
—use the Arrow keys to increase or decrease the number before you press the enter key.
—Press the key for the first (left-most) digit in the number until the display ‘rolls over’ and that digit
appears as the only digit on the display. Then proceed to enter the remainder of the number and
press the Enter Key.
—Or, press the Gross or net Key to return to Run Mode and then come back into the menu to try again