Kistler-Morse KM SVS2000 - Manual (Page 63)

59
www.kistlermorse.com
97-1129-01 Rev. D
2. Press the enter key to access this menu. The display looks like this:
RAW 12345600 lbs
Press the up Arrow key to toggle to the other pages of the display, which look like this:
FTR 12345600 lbs
OUT 12345600 lbs
RAW 1234567 Cts
FTR 1234567 Cts
SEnSOUT -123 mV
(Units are consistent with Disp Units.)
3. Press the enter key to return to:
69 SenSOr DISPLy
4. Press an Arrow Key to scroll to another menu or press the Gross or net Key to return to Run Mode.
Figure 12. Sensor Display
FIlTer Menu [70]
The Filter menu is used to set up the SvS2000’s filters — Averaging and the DSP Filter. Additionally, the Filter
menu allows you to monitor the DSP Filter. This chapter provides explanations of each of the filtering functions
and navigation procedures through the menu tree.
71 averagIng
This menu is used to set the number of individual readings (from 1 to 255) the SVS2000 averages for each
display reading while in Run Mode. The SVS2000 calculates a running average. The larger the number of
individual readings in the running average, the smaller effect a variation in signal will have on the average. This
results in fewer variations on the display reading and an easier to read display. Averaging affects the value seen
on the display as well as setpoints, current outputs, and serial outputs. The default value for Averaging is 1.
Follow this procedure to set the
Averaging value:
1. If the SVS2000 is in Run Mode, press the ‘7’ Key, ‘1’ Key, and Enter Key to access the menu tree. The
display shows:
71 AVERAGInG