Kistler-Morse KM SVS2000 - Manual (Page 46)

42
97-1129-01 Rev. D
www.kistlermorse.com
1In = 0 lbs 1OT = 0 lbs
2In = 6000 lbs 2OT = 5000 lbs
3In = 11,500 lbs 3OT = 10000 lbs
4In = 16000 lbs 4OT = 15000 lbs
5In = 20000 lbs 5OT = 20000 lbs
Figure 10. Linearization
Follow this procedure to set up and enable the linearization table:
1. If the SVS2000 is in Run Mode, press the ‘2’ Key, ‘3’ Key, and Enter Key to access the menu tree. The
display shows:
23 LIneArIZATIOn
2. Press the enter key to access this menu. The display shows:
LIneArIZe SeT
3. Press the enter key to access the Linearize Set menu. The display looks like this:
1In 0 lbs
(Units are consistent with Disp Units.)
4. Use the numeric or Arrow Keys to enter a value for the raw input for this point in the linearization table.
Press the Enter Key to save the value in memory. The display acknowledges the entry and proceeds to a
display that looks like this:
1OT 0 lbs
5. Use the numeric or Arrow Keys to enter a value for the corrected output for this point in the linearization
table. Press the Enter Key to save the value in memory. The display acknowledges the entry and
proceeds to a display that looks like this:
2In 2500 lbs
6. Repeat Steps 4 and 5 until the linearization table setup is complete. After the corrected output for point 5
is entered, the display returns to:
LIneArIZe SeT
7. Press the up Arrow key to proceed to the next menu. The display shows:
LIneArIZe enABLe