Kistler-Morse KM SVS2000 - Manual (Page 70)

66
97-1129-01 Rev. D
www.kistlermorse.com
(Asterisk indicates the current selection.)
If the displayed menu does not show matrl Track: On, press the up Arrow key to display the next page
of the menu:
TrACkIng By rATe
15. When the display shows TrACkIng By BOTH, press the enter key. The display acknowledges the
selection and returns to:
81 mAT TrACk enAB
16. Press an Arrow Key to scroll to another menu or press the Gross or net Key to return to Run Mode.
raTe MonITor [89]
This is a monitor only function. It displays the rate of change in the weight. Follow this procedure:
1. If the SVS2000 is in Run Mode, press the ‘8’ Key, ‘9’ Key, and Enter Key to access the menu tree. The
display shows:
89 RATE MOnITOR
2. Press the enter key to access this menu. The display looks like this:
• 2.0 lbs/m
(Units are consistent with Disp Units.)
If the rate of change is greater than Rate Threshld, the bullet is replaced by a rotating line.
3. Press the enter key to exit the monitor and return to:
89 RATE MOnITOR
4. Press an Arrow Key to scroll to another menu or press the Gross or net Key to return to Run Mode.
ServIce Menu [90]
The Service menu is used to set up a user defined access code and user-defined keyboard lockout code, test
the keyboard, test the nonvolatile RAM (nVRAM), and reset the nVRAM to default parameters. This section
provides explanations of each of the service parameters and navigation procedures through the menu tree.
91 uSer acceSS
The SvS2000 arrives from the factory without a user-defined access code in place, allowing the operator to
change any parameters in the system at will. The User Access function allows you to set up and/or change a
User Access Code. Once a Code is in place and activated, the operator(s) will be able to go into the menu tree
to view parameters, but will not be able to change parameters. If the operator attempts to change a parameter,
the SVS2000 prompts the operator to enter the User Access Code. Once the Code is entered, the operator can
change any parameter while remaining in the Function Mode (i.e., the Code is entered once per Function Mode
session, regardless of the number of parameters changed).
note: record the Code and store it in a safe place. If misplaced, call km for instructions on how to bypass the
Code.