Kenmore 385.16677 - Manual (Page 2)

IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliance, basic safety precautions should always be followed, including the
following;
Read all instructions before using this appliance.
DANGER
— To reduce the risk of electric shock;
1. An appliance should never be left unattended when plugged in. Always unplug this serger from the
electric outlet immediately after using and before cleaning. ,:::i
2. Always unplug before replacing a Serger bulb. Replace bulb with same typenrated, 15 Watts.
WARNING
— To reduce the risk of burns, fire, electric.shock or irijufy.tQ persons;
1
3.
5.
6
.
7.
8
.
9.
15
Do not allow to be used as a toy. Close attention is necessary when this Serger is used by or near
children. ..
Use this appliance only for its intended use as described in this..owher’s manual. Use; phly attachments
recommended by the manufacturer as contained Ш:this owner’s manual.
i . . I
Never operate this Serger if it has a damaged cord.or plug, if it is not working properly, .if it has been
dropped or damaged, or dropped.into water. . . ; ■;.; : ■
Return this Serger to the пеа|Й11ЙИЩЩ1111“0г serviCelGeoler-liPikaminaiion, repair, electrical or
mechanical adjustment. ..illif'’'
Never operate the applianceiwtth any air o’piiiil: blocked: feep ventilation openings of this Serger and
foot controller free from accuirn.ul.ation of lint,fdyst and loose cio;th.
Never drop or.inseft .any object into any opening;; |||
Do not usfiijiiiiliiii'" .
Do not operate where aerosol (spray);: products are being used or where oxygen is being administered.
To disconnect, turn all controls to the Off (“O”) position, then remove plug from outlet.
Do not unplug by pulling;.6h:cord. To unplug, grasp the plug, not the cord.
10. Keep fingers away from ail moving parts. Special care is required around the serger needle.
11. Always use the;proper: rieedie plate. The wrong plate can cause the needle to break.
12. Do not use
13. Do not pull or pusffilabric while stitching. It may deflect the needle causing it to break.
14. Switch this Serger off (“O”) when making any adjustment in the needle area, such as threading the
needle,changing the needle, threading the bobbin, changing the presser foot, and the like.
Always unplug this Serger from the electrical outlet when removing covers, lubricating, or when making
any other adjustments mentioned in this owner’s manual.
SAVE THESE INSTRUCTIONS
NOTE; Serger design and specifications are subject to change without prior notice.