3@wtri9 button – Kenmore 385.19365 User Manual
Page 75
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3@wtri9 Button
Cj) stitch pattern:
04
<D Thread tension dial: AUTO
d)
F: Satin stitch foot
($ Drop the feed dogs:Lowered position
(see page 24)
Q] Match the holes on the button with the horizontal slot on
the presser loot.
H] Lower the foot to hold the button In place.
m Turn the handwheel 5 times by hand until the needle
sewing to the right.
3] Press the stitch width control key or to set zigzag
width matching with the distance of the holes on the
button,
H] Check if the needle enters into the holes on the button
by turning the handwheel by hand.
[5] Readjust the
zigzag
width if necessary.
[7] Sew about ten stitches, then cut the threads leaving
about 4“ (10 cm). Trim both needle and bobbin threads
at the begining.
[S Pull the bobbin thread to draw the needle thread to the
bottom side of the fabric and knot the threads.
* After the button sewing is completed, raise the
feed dogs for normal sewing.
64