Kenwood UD-900M - Manual (Page 34)

Reception of radio broadcast
■ Displaying station names [Remote control unit only^
Station names composed of up to four digits of characters and / or symbols can be displayed on the preamplifier /
tunen display.
Example: To receive FIVI 93.4 MHz, input its name with characters "CBE", and preset them under numeric key [ 3 ].
1 Receive FM 93.4MHz, and enter the character input mode.
TUN[\G/CHARACTEn CHAMCTB
I ^ I I ^ I
<r-
a CIIII)
Set the A / B switch to
the "A" side
(Tp O [Z] ra
6
" "
0
2 Select the characters to be displayed with that station.
0 Display the desired character.
TUNING/CHARACTER
(D
Establish the selection.
0 h
-.r-
(D Repeat steps 0 and @ until all of the required
characters have been input.
• To select "C", press the UP segment three times.
• To insert a space, simply press the [DIGIT |key.
Blinking digit change to
the next digit.
Types of characters that can be
input
After having pressed the |CHARACTER|
key, press thelTUNING / CHARACTER
key to display the characters available.
l ABCD....... XYZ012...9-
- / " - + < ------
- Blank position
3 End the character input.
The character input also terminates automatically
when fourth character has been input.
Press the | CHARACT e Y i I key to terminate char­
acter input with three characters or less.
'SE
a (3H) b
In case you comnnit an input mistake,
press the [CLEAR [key and re-start from
the previous digit.
4 Preset them under key [
0 Press the ENTER key.
MEMORY" lights up.
SB
0 Press numeric key [ 3 ].
TUE
L) : SE
Press while "MEMORY" is lighted.
Example; When a station name is displayed with
the
I
DISPLAY
I
key.
34 u D-900/UD-900M (En)