Kenwood UD-900M - Manual (Page 75)

Be sure to adjust the present time before proceeding
the following.
To check timer program contents
I Remote control unit only|
Press the PROG. key.
*(3DD®
P R 0 B R H I 1
O Press the numeric key corresponding to
^ the program to be checked.
m S m S
• If no program is selected while the program No. indicators
are blinking, the previous display condition resumes.
• When a program is selected, its contents will be displayed
for about 3 seconds, and the previous display resumes af­
ter it.
To cancel timer program execution
I
Remote control unit only
I
'I Press the CLEAR key.
a ( CIIIII b
S E L R R T R R I J B R R I 1
Press the numeric key corresponding to
the program the execution of which is to
be cleared.
Program No.
CD tl □□ CD^^N^
U
Select the number
with a numeric key.
P N
The program contents are not cleared even when its
execution is canceled.
Re-activation of timer execution after cancel­
ing it
Since the program itself is retained in memory, check its
contents and perform the operation from the step ''Acti­
vate the execution of the program" as follows.
0 Press EXE. key.
@ Select the program No. to be executed by
pressing the numeric key under which it is set.
(D Adjust the volume and tone in case of timer
reception of broadcast or timer playback of
CD or tape.
0 Switch the power OFF.
■ Operation of one-touch timer
Press the O.T.T. key allows to switch power ON after
a specified time period, set in the unit of 30 minutes,
from the moment it is activated.
^ Set the timer ON time.
Press the O.T.T. key.
8 : G D O.T.T. lights up.
The ON time of the timer is displayed.
The displayed time is incremented by 30
minutes every time the key is pressed.
• When the key is pressed once, a time that can be di­
vided by 30 minutes and within 30 minutes from the
present time is displayed as the ON time. (Example:
When pressed at 7:40, "8:00" will be displayed.)
• The ON time is incremented in 30-minute steps, for
example from 0:00 to 0:30, 1:00, 1:30, and so on.
• The ON time can be set up to 12 hours later.
• The one-touch timer can be set even when the power
is OFF.
p Select a program source and adjust the
volume.
Select CD, TUNER or TAPE.
Switch the power OFF.
Press the POWER key
of the power amplifier.
■ The ON time can be checked by pressing the | O.T.T. |
key once.
When the power is switched ON, the sleep timer will
automatically be set to 60 minutes.
When the power is switched ON, the selected source
(CD, TAPE, TUNER) will be played.
To cancel one-touch timer activated
Switch the power ON,
or
Press the O.T.T. key until the O.T.T. indicator
goes off.
Notes:
1. If disc is not present while the CD input is selected or cassette
tape is not present while the TAPE input is selected, the last
broadcasting station received will be received again.
2. If the I ADJUST |key is pressed to set the clock, the one-touch
timer is released.
UD-900 / UD-900M (En) 75