Haltech E6X Manual DOS Version - Manual (Page 11)

E6X Manual
11
SECTION 1 Getting Started
CHAPTER 1 HALTECH ECU INSTALLATION
1.1 The ECU and associated hardware
The Haltech E6X system comprises the following components
Haltech Electronic Control Unit (ECU)
Coolant Temperature Sensor
Inlet Air Temperature Sensor
Throttle Position Sensor (TPS)
Manifold Absolute Pressure (MAP) Sensor
(1,2 or 3 Bar Sensor - purchased separately to main kit since it is optional in
some applications)
Main Wiring Harness
Haltech E6X system Instruction Manual
Programming Cable
Programming Disk
Relays
1.2 Installation Summary
The Following is a list of the procedures that will be followed in the installation of the ECU.
1. Mount Manifold Absolute Pressure Sensors.
2. Mount Coolant Temperature Sensors.
3. Mount Inlet Air Temperature Sensors.
4. Mount Throttle Position Sensors.
5. Mount Ignition Modules
6. Mount optional Exhaust Gas Oxygen Sensor (if used)
7. Route Main Wiring Harness and connect sensors and ignition module.
8. Mount and connect Power Relays.
9. Mount Fuse Block.
10. Mount ECU inside passenger compartment.
11. Locate and connect flying wires:
RED + 12 volts battery
GREY Ignition on 12 volts
BLACK Chassis ground
ORANGE (2 wires) Fuel Pump Circuit
12. Install and connect the optional Idle Speed Motor
13. Install and connect any Optional Outputs
14. Connect Trigger signal
15. Connect ECU and test.