Haltech E6X Manual DOS Version - Manual (Page 94)

E6X Manual
94
On Coolant Temp 0 – 127 °C / 32 - 261 °F
This field defines the coolant temperature above which Anti-
Lag is operational
The anti-lag system is can be enabled by a switch connected to Aux. In or by meeting all three
operating conditions stated above (the last 3 fields). Once the switch is enabled, if the
Throttle condition is met, the anti-lag system will be activated. The last two fields allow the
ALS to be activated when all three conditions are met regardless of the AUX In setting; this
allows the AUX In to be used for another purpose.
13.14 Air Conditioning
The Air conditioning function allows the ECU to intercept the vehicles Air Conditioning
request and grant or refuse the request based on the current operating conditions.
Throttle Pos. 5 – 100 %
This field defines the throttle position above which the Air
conditioning request is disabled. This condition is independent
of any other fields.
Engine Speed RPM 1000 – 15000 RPM
This field defines the engine speed above which the Air
conditioning request is disabled. This condition is independent
of any other fields.
Off Time (s) 0 – 70 s
This field defines a delay after which an Air conditioning
request will be allowed once the above conditions fall below the
set values.
Active AUX In. HIGH or LOW
This field defines the active state of the Air conditioning request
line installed in your vehicle. If the line is active high this
means that the signal on the line when an Air conditioning
request is made is ~5 volts and when the line is idle the voltage
is ~0 volts. If the line is active low this means the Air
conditioning request is ~0 volts and the idle line is ~5 volts
(refer to 4.2.4 The In/Out Set-up Page, p49).
13.15 Engine Control Relay
This feature causes the ECU to turn on the output when the ECU has power. This input can
be used to drive a relay that supplies power to the engine bay.
This input has no parameters.