Haltech E6X Manual DOS Version - Manual (Page 93)

E6X Manual
93
If the RPM exceeds this value the NOS system will be switched
off.
Min. Rpm 100 – 16000 RPM
If the RPM is below this value the NOS system will not be
activated.
Minimum Throttle 0 – 100 %
The NOS system will be turned on above this value.
Minimum Temp 0 – 127 °C / 32 - 261 °F
The NOS system will not be activated unless the engine coolant
temperature is above this value.
Ignition Retard 0 – 20 °BTDC
The ECU will provide an ignition retard whenever the NOS
system is engaged.
Start-up Delay 0 – 120 s
The ECU will prevent the NOS system operating regardless of
the above conditions until the period of time programmed in
this field has elapsed.
13.13 Anti-Lag Switch
WARNING:
DO NOT OPERATE ANTI-LAG FOR PROLONGED PERIODS.
EXHAUST AND TURBO TEMPERTAURES RISE, WHICH MAY
CAUSE ENGINE DAMAGE.
The Anti-Lag switch function allows turbo-charged vehicles to decrease the “lag” associated
with boost when the motor is not under full load.
Retard Value 0 – 70 °BTDC
The ignition timing is retarded by this angle when the Anti-Lag
conditions for operation are met.
% Inc. Fuel 1 – 50 %
The percentage of fuel increased during Anti-Lag operation.
Zero TPS ONLY ON or OFF
If the Anti-Lag function is to be used when the Throttle Position
Sensor value is zero then turn this function ON.
Zero Inj Time 1 – 16 ms
If the zero TPS only function is ON then this value determines
the amount of fuel injected at zero or no throttle. The valid
range is (1-16) ms.
Throttle Perc. 5 – 80 %
The throttle position value below which Anti-Lag is
operational. The valid range is (5-80)%.
On RPM 100 – 16000 RPM
This field specifies the RPM above which Anti-Lag is
operational.