Haltech E6X Manual DOS Version - Manual (Page 97)

E6X Manual
97
Active Sw. Posn. HIGH or LOW
This defines the active level or polarity of the signal. When this
field is set to HIGH the active output is 12V, when the field is
set to LOW the active output is 0V.
There are two possible configurations for this feature:
The first configuration is to have two throttle position ranges; one high and one low. In the
lower range the output is inactive and in the upper range the solenoid is active. Using this
configuration the “Switch On” field should be set to the throttle position limit of the upper
range and the “Switch Off” should be set about 5% below “Switch On”, forcing hysteresis in
the switching to prevent the output from oscillating around the switch point.
The second configuration is to set the output in the active state for a range of throttle position
and to set the output inactive outside this range. To do this the “Switch On” is set to the
lower throttle limit of the range and the “Switch Off” is set at the upper throttle limit, when
the throttle position is lower than “Switch On” the solenoid is disabled, when the throttle
position is greater than “Switch On” but less than “Switch Off” the solenoid is enabled, when
the throttle position is greater than “Switch On” and “Switch Off” then the solenoid is
disabled.