Haltech E6X Manual DOS Version - Manual (Page 41)

E6X Manual
41
If a sensor reading displays a fault condition like that of the coolant temperature in the above
picture it means that the ECU has detected that there is a problem with the sensor or the
wiring and that that part of the installation should be checked. In the case above the coolant
sensor has been disconnected and the circuit is open. Check all the sensors for operation as
far as is possible.
3.3 Hot Key Summary
Many of the menu items have shortcut keys or “Hot Keys” which allow the user to access a
menu item directly from anywhere in the programming software eliminating the need to
navigate the menu structure. These “Hot Keys” are as follows:
- CTRL-Q - Quit the Programming Software
- CTRL-F - Fuel Maps
- CTRL-I - Ignition Maps
- CTRL-M - Main Set-up
- CTRL-G - Ignition set-up
- CTRL-N - In/Out set-up
- CTRL-P - Program Set-up
- CTRL-S - Switch Mode
- CTRL-E - Engine Data Page
- CTRL-O - Output Options
- CTRL-W - PWM Outputs
- CTRL-T - Throttle Pump
- CTRL-D - Data log