Haltech E6X Manual DOS Version - Manual (Page 78)

E6X Manual
78
SECTION 3 Software Features
CHAPTER 10 PRINTING MAPS
You can print the maps and identification information to printers that accept IBM emulation
mode, such as IBM compatible dot matrix printers (consult your printer manual). The Print
function should work with other IBM compatible printers, but some special characters such as
°, ±, etc. may not print correctly. The print function is accessed through the menu structure
under the options menu.
There are four options for printing:
Set-up Information
This will print only the set-up pages
Maps
Prints all the maps in the system (i.e. Fuel, Ignition and Coolant).
Output Options
This function will print the current settings and the status of the
output options of the ECU. (i.e. turbo waste-gate).
Print All Information
This will print all of the above information
The system will ask for a name to print at the top of the printed output. This allows you to
differentiate between print outs if you have printed more than one set of maps. The name can
be up to ten characters in length.
The system pauses to allow you to set up the printer. Press any key to start printing. Before
you start printing the printer must be ONLINE and must have power and paper. To abort the
print job press ESC.