Interlogix UltraView PTZ Dome Series - Manual (Page 38)

CyberDome II
Installation Manual
30
Installing the camera assembly
Installing the camera involves securing the pan/tilt assembly to the upper housing.
Note: You may install the pan/tilt assembly while power is applied to the housing.
To install the pan/tilt assembly, see Figure 25 and do the following:
1. Insert the safety catch through the channel in the retaining bracket attached to the upper housing.
2. Push the spring latch handle outward, while pivoting the pan/tilt assembly up until it is vertical.
3. Secure the pan/tilt assembly by releasing the latch handle and engaging the catch tab.
4. Verify that the four mounting nuts mate with the four alignment holes.
Figure 25. Installing the pan/tilt assembly
Shroud and bubble dome installation
A camera shroud obscures camera orientation so subjects can’t be certain which direction the camera is
pointing. We also offer several types of camera bubbles—from transparent to smoke and one-way reflective
surfaces—to protect the camera and further hide the camera’s operation.
For flush-mount housings, install the PTZ assembly in the housing before attaching the shroud. For other
housings, it is easier to attach the shroud after the PTZ assembly is installed, but it is not required.
Alignment holes
Spring latch handle
Retaining bracket
Mounting nuts
Safety catch
Alignment holes
Mounting nuts