CK Electric Part C3000 - Manual (Page 60)

Chapter 2 Printing With the MultiPASS C3000 2-35
MPC-3000—USERS MANUAL/V000/07-97
Printing
Fabric Sheet FS-101
Fabric Sheet FS-101 for Canon printers comes with a booklet that
describes special handling procedures. Be sure to look through this
booklet for special information regarding the Fabric Sheet. This section
describes specific steps for using Fabric Sheets with the Canon Bubble
Jet products.
Be sure to follow these guidelines.
❍ To avoid paper jams, smearing, and other problems, do not open
the printer’s cover during printing.
❍ Do not touch newly printed fabric sheets until the ink is completely
dry. This takes about one hour.
N
❍ Do not use the fixing agent that comes with the Fabric Sheet FS-101.
This agent is NOT needed when printing with the MultiPASS
C3000.
Printing On a Fabric Sheet
❍ Make sure the paper thickness lever is to the right
position.
❍ Make sure the paper support and paper output tray are
extended.
Set up
the printer.
1
F
ABRIC_LO
AD
DO NOT TOUCH
THE GUIDE RAIL
DO NOT TOUCH
THE RIBBON
CABLE
OPEN END AT THE TOP