CK Electric Part C3000 - Manual (Page 86)

MPC-3000—USERS MANUAL/V000/07-97
Sending F
ax
es
Chapter 4 Sending Faxes With the MultiPASS C3000 4-3
The MultiPASS C3000 begins
scanning the document, and dials
the number.
❍ After a moment, the display shows the transaction
number for the fax. This is a unique number the
MultiPASS C3000 assigns to the document and uses to
identify the document in transaction reports:
The display continues to show these three displays in
order while the fax is being sent.
❍ The MultiPASS C3000 beeps once to indicate that the
document has been sent successfully.
The MultiPASS C3000 automatically redials if the receiving
fax does not answer, if the line is busy, or if a transmission
error occurs. You can specify the number of times it redials
using the Automatic Retries option in the Send Fax dialog
box of the MultiPASS Desktop Manager (see page 8-4). If all
redial attempts fail, the MultiPASS C3000 beeps
intermittently for a few seconds. If this happens, check the fax
number and try sending the fax again.
If the
ALARM
light is flashing, correct the error described in
the LCD display, and then press
STOP
. You may need to open
the operator panel to remove the document from the ADF
(see page 10-3).
TRANSMITTING OK
TX/RX NO. XXXX
TRANSMIT
SCANNING
SCANNING
START/COPY Press START/COPY.
3