CK Electric Part C3000 - Manual (Page 89)

❍ After scanning the document into memory, the
MultiPASS C3000 automatically dials each number in the
group.
❍ If there is no group registered under the one-touch speed
dialing button or the two-digit code, the LCD displays the
NO TEL # message. Make sure you entered the correct
number and that the group has been registered correctly
for group dialing.
❍ If you make a mistake when dialing, press
STOP
. You can
then try again.
Redialing
Manual
To start dialing again, just press
REDIAL
. The MultiPASS C3000 redials
the previous number you dialed with the numeric buttons. Make sure
the document is in the ADF.
Automatic
The MultiPASS C3000 automatically redials if the first attempt at
sending fails (for example, if the line is busy). The unit redials twice, and
the time between redials is two minutes. (These are the default settings.)
The LCD displays AUTO REDIAL and the transaction number while the
MultiPASS C3000 is redialing.
If the MultiPASS C3000 fails to make a connection after the last redial, it
beeps. The LCD displays BUSY/NO SIGNAL ; try sending again later.
You can change the number of redials and the time between redials. The
redialing options are set in the Send Fax dialog box of the MultiPASS
Desktop Manager; see page 8-4.
BUSY/NO SIGNAL
TX/RX NO. XXXX
AUTO REDIAL
MPC-3000—USERS MANUAL/V000/07-97
4-6 Sending Faxes With the MultiPASS C3000 Chapter 4