Microsoft Surface 3 - Manual (Page 44)

© 2014 Microsoft Page 44
Figure 3.10: Windows Deployment Services Configuration Wizard.
3. The Windows Deployment Services Configuration Wizard presents a series of steps, as follows:

Before You Begin – Shows a description of WDS and the prerequisites. Click Next.

Install Options – Select the Standalone server option to install WDS without active directory. Click Next.

Remote Installation Folder Location – Enter or select the path where you would like to store the WDS
components that will be accessed by the remote client and click Next. The selected folder must be located
on an NTFS volume and should not be located on the system volume.

PXE Server Initial Settings – Enables you to configure which clients will receive a response from WDS when
attempting to network boot, as shown in Figure 3.11. Select the applicable choice from the following, then
click Next:
o Do not respond to any client computers – Use this setting if you want to configure WDS without
enabling network boot, as in the case when you are staging and configuring a WDS server. This
scenario does not use this option.
o Respond only to known client computers – Use this setting if you want to configure which
computers WDS will respond to. This scenario does not use this option.
o Respond to all client computers (known and unknown) – Select this option, which ensures that
your Surface Pro 3 device can network boot without additional configuration. Additionally, the
Require administrator approval for unknown computers checkbox can be selected to require
approval through the WDS console for unknown machines. For this scenario, do not select this
option.