Microsoft Surface 3 - Manual (Page 53)

© 2014 Microsoft Page 53
8. Select the Import Drivers option from the Actions pane to launch the Import Driver Wizard, as shown in Figure
3.19.
Figure 3.19: Import Driver Wizard.
9. The Import Driver Wizard presents a series of steps.

Specify Directory – Enter or browse to the folder in which the extracted drivers are located and click Next.
Note: Drivers are imported at the folder level. Therefore, when you import drivers and specify a folder, all
drivers in that folder are imported. WinPE should have only those drivers necessary to boot and connect to
the network. In this scenario, only the Surface Ethernet Adapter drivers are required, so it is a good idea to
locate all other drivers in a separate folder.

Summary – Confirm the specified options and click Next.

Progress – A progress bar will be displayed as the drivers are imported.

Confirmation – Confirmation of the successful import of the drivers will be displayed here. Click Finish.
10. Repeat steps 7-9 and the Import Driver Wizard if required for the second Ethernet adapter folder.
Creating the WinPE Selection Profile
After the drivers for WinPE are imported into the deployment share, the deployment share needs to be configured to
use these drivers when creating boot media by following this procedure:
1. Expand the Advanced Configuration folder of the production deployment share in the Deployment Workbench.
2. Select the Selection Profiles folder.
3. Select New Selection Profile from the Actions pane to launch the New Selection Profile Wizard.
4. The New Selection Profile Wizard presents the following options: