Microtel MicroWin 2000 - Manual (Page 24)

MicroWIN 2000 Manual
Version 1.0
19
Once on the correct COM Port, look at the selection COM Type in the upper right corner. The
default is None. Change this selection by clicking on the down arrow and selecting Local.
To save this COM Port change, click on the OK button. The Setup MicroWIN Entries form
will again be displayed.
Connect the Dialer to the Computer
If this hasn’t already been done, take the RS232 serial cable and connect it from your Computer
COM Port that was just configured to the S1000’s Printer Port.
To review what has been done so far:
• A Dialer Entry was created that will be used to connect to the S1000 Dialer.
• The COM Port was setup that will be used to connect to the S1000 Dialer.
• A dialer has been connected to the setup COM Port.
Connecting Locally
MicroWIN 2000 is now ready to communicate with the dialer. Once the entry and dialer are
connected, the user will have the ability to view realtime status information of the dialer, record
this status information to the database for later retrieval, change the state of the dialer’s outputs,
retrieve dialer archives, etc.
Move to the Realtime Data form by clicking on the button at the bottom labeled Realtime. The
Realtime Data form will display this dialer’s realtime data once it is connected. All that is left to
be done is to tell MicroWIN 2000 to connect.