Microtel MicroWin 2000 - Manual (Page 26)

MicroWIN 2000 Manual
Version 1.0
21
If a problem occurs while connecting or a dialer alarm condition is present once connected, an
alarm signal may be sounded. To silence this alarm, click on the Silence button above Alarm
Condition picture.
For more information about specific alarm conditions that may occur while connected, read
section Entry’s Current Alarm Condition, Page 50.
Disconnect From Dialer
To Disconnect from this dialer, click on the button labeled Disconnect. After a little
handshaking, the entry and dialer will be disconnected and the COM Port will go back to being
unused.
Connecting Remotely
The following will now give a brief description of how to connect remotely.
First, there will need to be a dialer that is ready to be connected to remotely (See section Setup a
Dialer to Talk to MicroWIN 2000, Page 6). The process will be very similar to connecting
locally except for the following differences.
Move to the Setup COM Ports form again by clicking on the menu option Setup and clicking on
the selection Ports. Change to the port that has a modem connected to it and change the COM
Type to be a Modem. Then Save the port changes.
Change forms back to Setup Entries by clicking on the menu option Setup and clicking on the
selection Entries.