Microtel MicroWin 2000 - Manual (Page 88)

MicroWIN 2000 Manual
Version 1.0
Analog Output
They can be setup for a user to call in and manually set some motor level, or set some other
variable value.
The Output value (shown below) tells the output state of the Analog Output Channel. To
change it, click on the little button next to the value.
The normal condition is when the current output level value is between the High SetPoint and
Low SetPoint. The fault condition is when the level value is either above the High SetPoint or
below the Low SetPoint.
To change the value of any of these settings, click on the button next to the Output value. The
following form will be displayed.
To change the value, either drag the scroll bar on the right until the desired value is displayed in
the To Value field or simply type in the value right in the To Value field.
The drop down box at the top of the form shows the current scale used to figure out the To Value.
Maintain Output Level After Dialer Power Cycled (User Outputs Only)
While the dialer is turned on, its user commanded output channels can be set to certain values.
These values will remain until the power gets turned off. If these levels should be maintained
even after the dialer gets turned off and on, this should be selected.
If this is not selected and the dialer gets turned off and on, all outputs will be set to an Open State
and all analog outputs will be set to output at 0%.
83