Microtel MicroWin 2000 - Manual (Page 41)

MicroWIN 2000 Manual
Version 1.0
36
If all has been properly setup, the picture in the upper right hand corner will read CONNECTED
and after a little handshaking, the dialer’s realtime status information will start being displayed
and will update every 1 to 3 seconds.
If a problem occurs while connecting or a dialer alarm condition is present once connected, an
alarm signal may be sounded. To silence this alarm, click on the Silence button above Alarm
Condition picture.
For more information about specific alarm conditions that may occur while connected, read the
section Entry’s Current Alarm Condition, Page 50.
Transfer the Archive Configuration
Once properly connected, look down at the transfer information.
Click on the Send Config button. The Send/Receive Menu will be displayed.
This menu shows all the configuration data that will be sent to the S1000. To the right of the
label Send Selection, click the None button to unselect all the configuration settings. Then, click
on the Archive Info selection to mark this as the only data to send. Click on the button Send.