Microtel Series 500 - Manual (Page 19)

12
III.C.2 System Fuse
The internal System fuse is a 1/2 amp fuse, Little fuse #312.500, or equivalent. The
fuse is located on the Power Supply Board in a set of fuse holder clips.
SAFETY NOTICE!!
When inspecting or replacing the System fuse, unplug the System or turn off the
breaker supplying power to the System.
III.D.
Telephone Line Installation
The Microtel MCS 500 Dialer comes with a standard 3 ft. flat telephone cable for easy
connection to an RJ-11C type modular jack. The cable is connected to the Microtel
MCS 500 Dialer at the factory. The only field installation requirement is to insert the
male connector end of the cable into the user supplied RJ-11C jack. Refer to the
installation diagram located in the appendix for details on wire routing procedures.
The Microtel MCS 500 Dialer complies with part 68 of the FCC rules. On the inside of
this unit is a label that contains, among other information, the FCC registration number
and the Ringer Equivalence Number (REN). If requested, provided this information to
your Telephone Company.
The REN is useful to determine the quantity of devices you may connect to your
telephone line and still have all of those devices ring when your number is called. In
most, but not all areas, the sum of the RENs of all devices should not exceed five (5.0).
To be certain of the number of devices you may connect to your line, you should call
your local Telephone Company to determine the maximum REN for your calling area.
If the Microtel MCS 500 Dialer causes harm to the telephone network, the Telephone
Company may discontinue your service temporarily. If possible they will notify you in
advance. If advance notice is not practical, you will be notified as soon as possible.
You will be advised of your right to file a complaint with the FCC.
Your Telephone Company may make changes in its facilities, equipment, operations or
procedures that could effect the proper operation of the Microtel MCS 500 Dialer. If
they do so, you will be given advanced notice so as to give you an opportunity to
maintain uninterrupted service.
If you experience trouble with the Microtel MCS 500 Dialer, please contact Microtel at
206 West Judge Perez Drive, Chalmette, LA 70043, (504) 276-0571, for repair /
warranty information. The Telephone Company may ask you to disconnect the
equipment from the network until the problem has been corrected or you are sure that
the equipment is not malfunctioning.