Microtel Series 500 - Manual (Page 64)

57
MCS 500 Remote Operation Procedure Flowchart
Remote Operations Base Point
“System Ready” [Select Category 0–7]
System Category
0
“Please Select the System Function” [Enter Digit]
1 System Recites ID Message
# “Please Enter the System ID Message Now” [Speak Message]
2 System Recites Current Alarm Status Message
3 System Recites All Call Terminate Mode Information
#
“Please Select the Call Terminate Mode” [Enter Digit]
1 “The Call Terminate Mode is – Not Active”
2 “The Call Terminate Mode is – Active
3 “Alarm Not Acknowledged”
4 “Alarm Acknowledged Accepted” (plus applicable Snooze Period Information)
# The System Recites the Current Mode and Hangs Up
4 “The Snooze Period is MMMM Minutes”
# ”Please Enter the Snooze Period” [Enter MMMM]
5 “The Time is HH Hour and MM Minutes”
# ”Please Enter the Time” [Enter HHMM]
6
“The Date is MM/DD/YY”
# ”Please Enter the Date” [Enter MMDDYY]
7 “The Call At Function Will Call List Number LL”
# ”Please Enter the Call At List Number” [Enter LL]
Digital Input Category
1 “Please Select the Digital Input Channel” [Enter XX]
“Digital Input Channel XX, Ready” [Enter Digit]
1 System Recites Channel ID Message
# “Please Enter the ID Message Now” [Speak Message]
2 “Digital Input Channel XX is (in Alarm or Normal)”
3 “Digital Input Channel XX Mode is (Active, Not Active, or Not Available)”
#
“Toggles and Recites Current Mode
4 “Digital Input Channel XX Will Call List Number LL”
# ”Please Enter the List Number” [Enter LL]
5 “Digital Input Channel XX Totalizer Reading is NNNN”
# Resets and Recites Totalizer Value
6
“Digital Input Channel XX Total Time is HHHH Hours and MM Minutes””
# Resets and Recites Total Alarm Time Accumulator
7 “Digital Input Channel XX Time In Alarm is MMMM Minutes and SS Seconds”