Microtel Series 500 - Manual (Page 2)

**********************************
IMPORTANT
******************************
When any new version of software is installed, you must initialize System, Phone, and
I/O Default Data in order to prevent unpredictable results, even if after installation the
system appears to be operating correctly.
Refer to sections III.E INITIALIZING THE SYSTEM and III.F I/O OPTION CARD
INSTALLATION of this manual, or perform the following procedure in order to correctly
reinitialize the dialer.
When in the main System Status Screen, press the SEQUENCE key to enter the Dialer
Test and Setup Screen. Cursor to the SYSTEM DATA field in the initialize Default Data
column, and press the SELECT key.
After the System Date has been initialized, move the cursor to the PHONE and I/O
DATA field and press the SELECT key.
After the PHONE and I/O DATA has been initialized, the I/O cards must be reinitialized.
Move to the Select I/O Cards field and press Select to enter the Select Device Type
Screen. Using the PREVIOUS and NEXT keys, move the highlighted cursor to each
card slot position and use the SELECT key to toggle the entry to the physical card type
which occupies that slot. After selecting the proper card type for any card position,
highlight and SELECT the INITIALIZE field to setup the system’s memory for that type
of card. When the inventory of I/O Option Cards is correct, move the highlighted cursor
to the EXIT field and press the SELECT key.
Finally, when in the Dialer Test and Setup Screen move the highlighted cursor to the
EXIT field and press the SELECT key to return to the main System Status Screen.
The System Setup, Calendar, Power, Telephone List and Directory, and individual I/O
channels must now be programmed as desired for the application. Follow the
instructions in the relevant sections of this manual in order to complete the
programming of the dialer.