Conair 100 - Manual (Page 57)

To S t a r t D r y i n g
1 Make sure there is material in the hopper.
2 Turn on the main power to the dryer
.
Make sure the dryer’s
disconnect dial is in the ON position. This powers up the con-
trol and the display lights will illuminate.
3 Set the drying temperature. Use the Scroll
button to get to the Process Temp function.
Press the Adjust Setpoint ▲ or
Jbuttons to
select the temperature.
(continued)
Set Point Actual
1 Process Temp.
2 Regen. Temp.
3 Return Air Temp.
4 Auto Start
5 Load Time (MDC)
6 Activate Setback Temp.
7 Setback Temp.(Process)
8 Setback Load Rate
9 PM1 Dewpoint
Shutdown Alarms
A1 Process High Temp.
A2 Process Loop Break
A3 Process Heater High Temp.
A4 Regen. Heater High Temp.
A5 Carousel Index Too Long
A6 Carousel Index Failure
A7 Return Air High Temp.
Passive Alarms
P1 Process Temp. Deviation
P3 Regen. Temp. Deviation
P5 Return Air High Temp.
Auto Start
Desiccant Indexing
Set-Back Temp.
Process Blower
Process Pressure
Process Heater
Regen. Blower
Regen. Pressure
Regen. Heater
4
Opera
tion
Central
When configured as a central dryer, the drying temperature can
not be set since there is no process heater in the system.
O p e r a t i o n l 4 - 1 7