PRG Mbox Designer Manual 3.9 - Manual (Page 117)

MBOX ® MEDIA SERVER USER MANUAL 109
SYNCHRONIZATION
Timecode Synchronization (Timecode Sync Playmode)
Mbox allows movie playback to be synchronized to external SMPTE or MIDI timecode, or a simple internal clock. The
timecode sync works with both 30 fps non-drop and 30 fps drop-frame timecode and requires the use of either the TC
Reader application (explained later in this section) or the Mbox Remote application (refer to the Mbox Remote User
manual for more information).
By default, with no action taken by the user, every movie file is automatically linked to a time of 01:00:00:00
(HH:MM:SS:FF). Therefore, to simply trigger any file, set it to the timecode sync playmode (see below) and then run
the clock signal up to 1 hour. The default timecode setting can be changed using the preferences available in the
Mbox Remote application. The preference is called "TC Default" and the format is HH:MM:SS:FF. (Refer to the Mbox
Remote User manual for more information.)
There are two timecode linking methods:
1) Using a .plist file to link files to timecode start times.
2) Using TC DMX Controls.
Guidelines:
+ Both timecode linking methods can be used at the same time.
+ Sync times generated by the TC DMX Controls method will override times generated by entries in the plist file.
Linking Files to Timecode (Method 1)
A Property List (plist) document can be created to hold the timecode values for any or all files on the server. The file
should be called
MediaTimeCodes.plist and should be placed in the Mbox/Media folder. This plist file is a simple set
of Key:Value entries, where each key is a media index (folder.file) with a linked timecode value (HH:MM:SS:FF). Refer
to the example window below: