Toa VM-3000 Series - Manual (Page 29)

29
Step 1. Press the broadcast zone selector key to select the broadcast zone.
The selected zone’s indicator lights green, allowing the automatic announcement assigned to that key
to be broadcast.
Step 2. Press the automatic announcement start key to start the broadcast. The automatic announcement
indicator lights green and the automatic announcement is broadcast over the selected zone.
Step 3. When the automatic announcement playback is complete, the indicator goes out and the broadcast is
terminated.
Note
Pressing the automatic announcement start key partway through playback causes the broadcast to be
terminated and the indicator to go out.
Broadcast zone selector key /
Automatic announcement start key
Automatic announcement start indicator
[RM-200M]
• Assign a broadcast zone selection to the key.
(Refer to "RM Function Key Settings" in "Event Settings" in the separate software instruction manual.)
• Assign an automatic announcement function to the key.
(Refer to "RM Function Key Settings" in "Event Settings" in the separate software instruction manual.)
5.2.2. Automatic announcement broadcasts
This function makes general broadcasts by activating and playing back automatic announcements recorded
and stored in the VM-3360VA or VM-3240VA.
Perform the following settings in advance using the setting software: