Toa VM-3000 Series - Manual (Page 56)

56
[Resetting failures at the RM-320F]
Press the Failure Reset key.
The Failure Reset indicator remains lit while the key is held down.
Failure Reset key
Failure Reset indicator
Lit
[Resetting failures by the control input]
Failure reset can also be performed by using the control inputs of the VM-3240VA, VM-3360VA, VM-3240E,
and VM-3360E. (Refer to "Event Settings" "General Control Input Settings" in the separate software
instruction manual.)
VM-3240VA/3360VA/3240E/3360E
Control input
Failure
acknowledgement Failure
reset
Notes
• The RM-320MF's Failure Reset function is valid only when all the versions of VM-3000VA firmware, VM-
3000E firmware, and VM-3000 Setting Software are 2.00 or later.
• The "Failure Reset" function must be assigned to the key in advance. If this function is not assigned, the RM-
320F cannot be used for failure reset.
• The Failure Reset function can be assigned using the setting software. (Refer to "Event Settings" "RM
Function Key Settings" "RM-320F Settings" in the separate software instruction manual.)