Toa VM-3000 Series - Manual (Page 59)

59
MIC SP CPU OFF ON
Failure indicator Failure indicator
Switches from
steady on to
extinguished mode.
Lights while
the right-hand key
is pressed.
Switches from
steady on to
extinguished mode.
RM-300MF RM-320F VM-3240VA/3360VA
GENERAL
FAULT Cancel key
Failure Reset
key
Step 2. Determine and remedy the cause.
If the cause cannot be determined from the VM-3360VA or VM-3240VA’s on-screen display, connect
a PC and load the log data using the setting software. (For log data loading, refer to "Log Display" in
the separate software instruction manual.)
Step 3. Press the VM-3360VA or VM-3240VA’s [CANCEL] key (to reset the failure).
The Failure indicators on the VM-3360VA or VM-3240VA and the RM-320F go out, allowing normal
system operation to be restored.
Note
The "Failure Reset" function must be assigned to the Failure Rest key in advance. If this function is
not assigned, the RM-320F cannot be used for failure reset. This function can be used only when all
the versions of VM-3000VA firmware, VM-3000E firmware, and VM-3000 Setting Software are 2.00 or
later.